Return to Division 7's Home Page.
Uniform Component
|
Additional Comments |
| Blouse |
The Tucked variant is no longer authorized. Refer to the Wear and Care page for videos on how to properly roll up the ODU Blouse sleeves. |
| Pants |
Bloused with safety boots. Blousing bands are optional; if not used, trousers can be tucked into the boot, and then adjusted to appear bloused. Pockets will lay flat. Refer to the Wear and Care page for a video on how to properly blouse your boots. |
| Undershirt |
Worn under the ODU Blouse. "USCG AUXILIARY" can be printed or embroidered on the left front but is not required. T-shirt must be dark blue. |
| Collar Insignia |
Sew-on cloth insignia are required. Metal insignia are not authorized. |
| Name Tape |
Cloth name tape is sewn above right pocket and must not be shorter than or extend beyond the width of the ODU breast pocket. Direct embroidery on blouse is not authorized. |
| Auxiliary Tape |
Cloth "USCG Auxiliary" tape is sewn above left pocket and must not be shorter than
or extend beyond the width of the ODU breast pocket. Direct embroidery
on blouse is not authorized. |
| Qualification Devices |
Only one embroidered insignia patch is authorized. Direct embroidery on blouse is not authorized. Insignia will be the same size as the
metal insignia. They must not be shorter than or extend beyond the width
of the ODU breast pocket. |
| Breast Device |
The AUXOP Device and Staff Badges are to be worn 1/4 inch over the right breast pocket. See AUXMAN for proper wear instructions. |
| Socks |
Black calf-length or longer athletic socks. |
| Boots |
Black 8 to 10 inch tall composite safety boots. |
| Belt |
Basic riggers belt. |
| Cover (Hat) |
Standard USCG Auxiliary ball cap, cold weather cap, or watch cap as
weather dictates. Metal member or office collar insignia placed on the
center front of the ball cap. Insignia must match the insignia sewn onto the blouse's collar. |
| Special Care Instructions |
The ODU is machine washable on a permanent press setting. Wash uniforms in warm water with a mild detergent. Do not use chlorine bleach. If hand washing, wring gently and rinse with warm water. For best results, dry ODU items at a low heat or tumble dry for 10 minutes, then hang on a rust-proof hanger to finish drying. Uniform may be pressed but be sure to set iron to the cooler setting for nylon/cotton blends. A pressing cloth is helpful to avoid shiny spots from the iron. Military creases are not authorized. |
